The first version of the radius rod was supposedly introduced to the production line on De
In the last installment of Resto Shop, we covered a mono-to-multi–leaf spring conversion. In order to combat the effects of the less-than-stellar mono leaf springs coupled with the non-staggered shocks (a double whammy for the ’67 Camaro), Chevy engineers came up with the radius rod. It helped reduce leaf spring wrap-up and wheelhop. This design worked well enough to carry the Camaro through to the ’68 model when Chevy started offering multi-leaf springs for select models and was able to retool the plants for the staggered shock design.
There were two different radius rod designs for production use. The first production design was a round radius rod that, according to research, started being installed at the plant on December 15, 1966. The second design went into production in May of 1967, with a rectangular rod and an additional travel-limiting bracket, which limited the amount the pinion could lift while the mono leaf spring was being twisted out of shape during hard acceleration. There were definitely designing and production changes being made prior to December because we have seen vehicles with original housings with the radius rod bracket, but no provision in the floorpan for the body bracket.
David Boland’s ’67 Yenko Camaro has a 05D production date, so it came factory equipped wit
This the front bracket of David Boland’s big-block four-speed ’67 Yenko which shows how th
A close-up of the radius rod travel-limiting bracket shows how it mounts to the axle brack
There was also a Service Bulletin retrofit kit for Camaro owners with driving woes due to the lack of a radius rod or were equipped with the first design without the limit bracket. This kit later changed to swap to the rectangular bar and limit bracket for Camaros previously equipped with only the round radius rod. The kit included instructions on how to weld the body bracket to the framerail if it didn’t have the post-December production mounting locations and also showed how to weld the axle bracket to the housing.
Production use of the radius rod was only listed for higher-optioned V-8 Camaros. Factory use of both round and rectangular bars was mostly regulated by drivetrain equipment (with some irregularity) and continued throughout the production run of ’67 models at both plants.
Special Thanks to Brian Henderson of Super Car Workshop, David Boland, and www.pacecarcamaros.com.
Have the Coolest Camaro Around!
Brought to you by Eastwood
Eastwood Thermo-Coustic sound and heat deadener reduces exhaust heat and noise from the interior of your Camaro. Using “Hi-tack” adhesive, a high-performance aluminum facing, and 0.060-inch thick butyl rubber material, Thermo-Coustic installs easily, conforming to any surface. Use on floor pans, door panels, trunk areas, or anywhere else you need to reduce road-noise or heat. Thermo-Coustic is the best bang for your buck! Each kit covers 33.75 sq. ft. and contains 9 sheets measuring 18x30 inches. Only $149.99! Buy 2 or more for $129.99! http://www.eastwood.com/eastwood-thermocoustic-material.html